At the point closest to the drain the slope will be higher than the.
Shower floor slope fix.
I recommend taping off the rectangular area where you stand most.
There is a single drain at the south end but the floor peaks in the middle so half the floor slopes to the drain in the south end but the floor to the north of the middle slopes to the end where there s no drain and water thus pools.
I think i m going to fix this.
You do a run at 1 4 minimum per foot to the farthest corner.
The builder seller is going to fix it.
Looking for some advice.
On top is a reviving old thread.
The glass door which swings in and out is centered on the sill and has a plastic deflector at the bottom so the amount of water is not huge.
This is so that the bottom row of tile is level.
After a shower the water may take up.
The picture attached shows the floor you may or may not notice the corner of the shower floor dips a bit and levels off it does not have the proper slope from the corner down to the drain hence my need to build that up a bit to.
It s on the order of a teaspoon to a tablespoon each shower.
I just finished tiling the shower floor.
Mark off the area of the floor that you want to apply the formula.
Underneath it is a mortar 1 4 per foot slope to a linear drain.
As a result every time we take a shower a small amount of water runs out and down the front face of the sill and if not wiped up promptly soaks into the floor.
It s an easy fix with the right tools and products and i can show you how it s done by a tile professional.
Was your shower floor never built correctly and no matter what you do there is always standing water that never reaches the drain.
Strike a level line all the way around the shower.