Fix a sink stopper.
Sink stopper won t seal.
A pivot rod that connects to the back of the drain pipe a perforated strap a clevis and a screw that locks the strap onto the stopper rod.
It moves the stopper in the opposite direction to the lift rod.
Unthread the sink stopper s tailpipe from the underside of the drain.
If your sink pop up won t pop up or seat properly fixing it is quite easy usually just a matter of adjusting a few parts.
Remove clip from ball rod.
If a sink won t hold water look up behind the sink with a flashlight if needed to identify the following parts.
The photo on the right fig.
It s easy to fix a bathroom sink drain plug that s leaking.
Water may leak or refuse to drain around a sink pop up for a number of reasons.
Most sink stopper tailpipes are made of pvc and will be connected to the drain with a pvc compression nut that you can loosen by hand.
The clicker may have been over tightened causing the.
The photo on the left fig.
The culprit is often a buildup of hair around the base of the stopper or the pivot rod mechanism.
Gasket to push outward.
How to fix a sink pop up drain stopper.
Peek above the sink to make sure the stopper is fully closed and that the pop up rod is pushed all the way down 3.
Re tighten the thumb screw by turning clockwise.
To remove unthread the rod nut pull the ball rod out and remove the stopper from the drain.
The ball rod is inserted into the side of the drain and attached with a nut.
If water still does not hold in the sink the next check will be the actual stopper seal.
When you push or pull on the lift rod it activates a lever the extends through the drain tailpiece.
But sink stoppers fail.
Now that the bottom of the tailpipe if free from the p trap loosen the nut that connects it to the threaded bottom of the sink drain.
Find replacement parts on amazon.
6 shows the gasket seated correctly between the clicker assembly and the stopper.
5 shows the gasket pushed out of position.
This is a repair you can do yourself.
The ball rod holds the stopper in the drain.
Simply remove the plunger clean and if necessary replace.
A sink stopper mechanism isn t difficult to understand.
The lever hooks onto the stopper through a hole or hook on the bottom of a long plastic flange that s attached to the stopper.
A sink stopper with a push pull rod control at the faucet is a great modern convenience.
When they do they are often unsightly and an irritation.
Remove stopper from drain.
